Trane TR170 - Introduction; Purpose of the Manual; Document and Software Version; Safety Symbols

1Introduction
1.1 Purpose of the Manual
This programming guide provides information for
advanced programming of the frequency converter. It
provides a complete overview of all parameters and
descriptions for all parameters.
The programming guide is intended for use by qualied
personnel.
To operate the frequency converter safely and profes-
sionally, read and follow the programming guide, and pay
particular attention to the safety instructions and general
warnings.
1.2 Document and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome.
Edition Remarks Software version
BAS-SVP16B-EN Update to new
software version and
addition of TR170.
2.9x
Table 1.1 Document and Software Version
1.3 Safety Symbols
The following symbols are used in this guide:
WARNING
Indicates a potentially hazardous situation that could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation that could
result in minor or moderate injury. It can also be used to
alert against unsafe practices.
NOTICE
Indicates important information, including situations that
can result in damage to equipment or property.
1.4 Safety Precautions
WARNING
HIGH VOLTAGE
Frequency converters contain high voltage when
connected to AC mains input, DC supply, or load sharing.
Failure to perform installation, start-up, and maintenance
by qualied personnel can result in death or serious
injury.
•
Only qualied personnel must perform instal-
lation, start-up, and maintenance.
WARNING
UNINTENDED START
When the frequency converter is connected to AC mains,
DC supply, or load sharing, the motor can start at any
time. Unintended start during programming, service, or
repair work can result in death, serious injury, or
property damage. The motor can start with an external
switch, a
eldbus
command, an input reference signal
from the LCP or LOP, via remote operation using Trane
Drive Utility (TDU), or after a cleared fault condition.
To prevent unintended motor start:
•
Press
[O/Reset]
on the LCP before
programming parameters.
•
Disconnect the frequency converter from the
mains.
•
Completely wire and assemble the frequency
converter, motor, and any driven equipment
before connecting the frequency converter to
AC mains, DC supply, or load sharing.
Introduction Programming Guide
BAS-SVP16B-EN 02/2017 All rights reserved. 3
1 1