No. Description Warning Alarm Trip Lock Parameter Reference
32 Motor phase W missing – (X) (X) Parameter 4-58 Missing
Motor Phase Function
38 Internal fault – X X –
44 Ground fault 2 – X X –
46 Gate drive voltage fault – X X –
47 24 V supply low – X X –
50 AMA calibration failed – X – –
51 AMA check U
nom
and I
nom
–X – –
52 AMA low I
nom
–X – –
53 AMA motor too large – X – –
54 AMA motor too small – X – –
55 AMA parameter out of range – X – –
56 AMA interrupted – X – –
57 AMA time-out – X – –
58 AMA internal fault X X – –
59 Current limit X – – –
60 External interlock – X – –
66 Heat sink temperature low X – – –
69 Power card temperature X X X –
79 Illegal PS cong X X – –
80 Frequency converter initialised to default value – X – –
84 LCP error X – – –
87 Auto DC brake X – – –
92 No-Flow (X) (X) – Parameter 22-23 No-
Flow Function
95 Broken belt X X – Parameter group 22-6*
Broken Belt Detection
126 Motor rotating – X – –
127 Back EMF too high X – – –
201 Fire mode X – – –
202 Fire mode limits exceeded X – – –
250 New spare parts – X X –
251 New type code – X X –
Table 4.1 Alarm/Warning Code List
(X) Dependent on parameter
A trip is the action when an alarm has appeared. The trip coasts the motor and can be reset by pressing [Reset] or via a
digital input (parameter group 5-1* Digital Inputs [1]). The original event that caused an alarm cannot damage the frequency
converter or cause dangerous conditions. A trip lock is an action when an alarm occurs, which may cause damage to the
frequency converter or connected parts. A trip lock situation can only be reset by a power cycling.
Warning yellow
Alarm ashing red
Table 4.2 LED Indication
The alarm words, warning words, and extended status words can be read out via eldbus or optional eldbus for diagnosis.
See also parameter 16-90 Alarm Word, parameter 16-92 Warning Word, and parameter 16-94 Ext. Status Word.
Troubleshooting Programming Guide
BAS-SVP16B-EN 02/2017 All rights reserved. 97
4
To Next Page
Loading...
