page 22 XL1050 User Guide
Changing Period Start or End Times
1. Press anywhere in a Period to make it active.
Other Periods will dim and the Start and
End times for this Period will be in black
boxes at the top of the screen.
2. Press TIME START or TIME END and
adjust the time using the UP and DOWN
arrows. Note: The XL1050 uses intelligent
technology and will not allow setting an
illogical start or end time. Periods must be
at least 30 minutes in duration.
Changing Period Set Points
1. Press the active Period’s Cooling or Heating
Temperature Set Point.
2. Adjust the Set Point using the UP or DOWN
arrows.
Changing the Period Name
1. Press the PERIOD NAME (Wake, Away, etc.).
2. Select a predened name or press NEW and
select NEXT.
3. If selecting a new name, enter the name
using the on-screen keyboard.
4. Press NEXT.
Changing the Schedule (cont.)
Day
Time
Start
Time
End
CancelApply
75º
70º
75º
70º
75º
70º
Wake Home
Sleep
Cool To
75º
70º
Away
6:00pm6:00am 8:00am 10:00pm
Press to adjust start and
end times
To change temperature settings press in the red or blue
area, then adjust the setting up or down with the arrows
on the right.
To rename a Period,
press in the gray area.
When all changes have been made, press Apply
to save and exit or press cancel to discard all
changes that were made to this schedule.
Schedule Mon Tue Wed Thu Fri Sat Sun
To Next Page
Loading...
