32-5093-04A-EN page 29
Advanced Z-Wave Settings
Nexia’s ADVANCED SETTINGS screen contains
three very powerful functions. Each of these
functions is very specic and should be
approached with a measure of caution. They
cannot be “undone.”
Learn
This function copies a new Z-Wave network to
the bridge from another controller. In addition,
it removes all current devices from the bridge.
Unregister
Removes the bridge from Nexia. All remote
control features will be disabled.
Factory Reset
Resets all Z-Wave information and removes
all devices from the bridge. If this bridge is the
primary controller for your network, resetting it
will result in all the devices in your network being
removed. Following the reset, it will be necessary
to remove and then add all of the devices back to
your network.
Bridge Information
If this bridge is being used as a secondary or
inclusion controller in the network, please reset
this bridge only in the event that the primary
controller is missing or otherwise inoperable.
Z-Wave Bridge
Factory
Reset
UnregisterLearn
Home Back
Connected to Nexia
Z-Wave network active with 2 nodes
To Next Page
Loading...
