To Next PageTo Next Page
Need help?Do you have a question about the Trane UC1C100A9481A series and is the answer not in the manual?
General| Category | Furnace |
|---|---|
| Fuel Type | Natural Gas |
| Ignition Type | Hot Surface Ignition |
| Heat Exchanger Material | Aluminized Steel |
| Input BTU | 100, 000 BTU/h |
| Stages | 1 |
Warns about carbon monoxide risks and outlines safe operation steps.
Warns about potential fire and explosion hazards from improper servicing or operation.
Details requirements for venting, materials, and classification (Category IV).
Provides maximum vent lengths for upflow/horizontal installations by pipe size and model.
Lists maximum vent lengths for downflow/horizontal setups by pipe size and model.
Details required clearances for direct vent terminals in Canada and US.
Details required clearances for non-direct vent terminals in Canada and US.
Provides guidelines for horizontal wall venting, including terminal placement and insulation.
Details mandatory installation of CO detectors for side wall vented appliances.
Covers required signage and inspection compliance for installations.
Illustrates the field wiring connections for a single-stage heating furnace setup.
Covers gas piping codes, drip leg installation, and pressure testing disconnection.
Explains how to check gas flow, calculate input, and adjust the gas valve.
Explains derating furnace input for installations at higher altitudes.
Outlines the necessary checks before initiating furnace operation.
Explains the burner box limit device and lists common abnormal operating conditions.
Lists and explains error codes generated by the integrated furnace control module.
