What to do if Trane WDS Accessories battery life at 25%?
If your Trane Accessories battery life is at 25%, it is recommended to replace the batteries. Also, a flashing symbol indicates that approximately 14 days of operation remain before the battery is too weak to power the sensor.
General| Brand | Trane |
|---|---|
| Model | WDS |
| Category | Accessories |
| Language | English |
Describes the WDS sensor with LCD display and configurable features.
Describes the WTS sensor which measures and transmits zone temperature only.
Describes the WZS sensor which transmits zone temperature, setpoint, and occupancy info.
Lists available wireless sensor models by their respective part numbers.
Provides specific dimension details for all wireless sensor models.
Critical placement advice for optimal radio signal strength and reliability.
Recommended mounting height for accessibility and optimal operation.
Guidance on suitable surfaces for mounting receivers and sensors.
How to set unique addresses for receiver/sensor association.
Steps to attach the receiver's mounting plate to the surface.
Instructions for connecting the receiver to the unit controller.
Steps to pair a sensor with its receiver.
How to check communication quality and battery levels.
Details on setting up the WDS sensor's features.
Function for after-hours temperature/fan adjustments.
How to initiate a service request from the sensor.
How to use the WDS sensor in normal operation.
How to adjust the desired temperature setting.
How to select system modes like heat, cool, or auto.
Identifies diagnostic indicators on receiver and sensors.
Interpreting blinking patterns and error codes for troubleshooting.
Procedure to check wireless communication quality.
Procedure to check the sensor's battery level.
Practical steps to verify wireless system performance.
Covers battery type, life, and installation.
Specifies required batteries and expected duration.
Instructions for inserting batteries correctly and safely.
Procedures for pairing and unpairing devices.
Steps for replacing failed sensors or receivers.
Methods to test sensor transmission and overall system.
Understanding default states and measuring resistance.
Guidelines for cleaning and general upkeep.
Detailed technical data for all wireless sensor set models.
Diagram showing wiring with one transformer.
Diagram showing wiring with multiple transformers.
Details on FCC, CSA, and IEEE compliance standards.
To Next Page
