Trane WSC036E - Pre-Start; Space Temperature Averaging (Reliatel Only)

RT-SVX23F-EN 33
Pre-Start
Space Temperature Averaging (ReliaTel™
only)
Space temperature averaging is accomplished by wiring a
number of remote sensors in a series/parallel circuit.
Using the BAYSENS016* or BAYSENS077*, at least four
sensors are required to accomplish space temperature
averaging. Example #1 illustrates two series circuits with
two sensors in each circuit wired in parallel.The square of
any number of remote sensors is required. Example #2
illustrates three sensors squared in a series/parallel circuit.
Using BAYSENS077*, two sensors are required to
accomplish space temperature averaging. Example #3
illustrates the circuit required for this sensor. Table 7, p. 35
lists the temperature versus resistance coefficient for all
sensors.
Figure 41. Examples