BAS-SVX04C-EN • Wireless Sensors 27
Installation
3. Press the left and right arrows for 4 seconds.
Note: If you try to access a feature that is locked, the locked symbol will appear on
the display.
If you press a keypad button to try change a locked setting, the locked symbol will
flash.
Replacing the Sensor Cover
To replace the cover:
1. Hook the cover over the top of the back plate. Apply light pressure to the bottom of
the cover until it snaps in place.
2. Install the security screw into the bottom of the cover (if desired).
To Next Page
Loading...
