SYSTEM
SET-UP
•Press HEAT/COOL to initiate the next
Set-Up which enables you to change
from Fahrenheit to Celsius. When the
word Temp comes up under the clock,
press the ARROW keys to choose
between F and C.
•Press HEAT/COOL again and you’ll
see Addr for the zone address. The
only reason to adjust this Set-Up is
if your home has more than one
heating/cooling zone.
Most Home Comfort Sensors control only
one zone anyway, so leave this one on the
factory setting (01). If you have more than
one zone, this is an adjustment best left to
technicians.
Here’s something you need to know:
When you change this setting, all of the set-
points and setbacks you scheduled so carefully
will revert to factory settings. You may also
lose factory calibrations.
15
To Next Page
Loading...
