Chapter 3 • Fitting Your Transcend • page 14
5. Gently squeeze the sides of the arm bar to slide the mask further or closer to
the face, so that it fits comfortably against the nose.
6. Adjust the headgear straps until the interface feels secure.
7. Once the interface is properly fitted, slightly tighten the top headgear straps
that connect to the CPAP so that you may lie down.
8. Make sure that the rear headband is still seated at the nape of the neck.
9. Adjust the interface straps or mask adjustments as necessary so the
interface creates a complete seal against the face. The interface should feel
secure while lying down, but the CPAP will shift slightly with movement of
the head.
5
7
FITTING
To Next Page
Loading...
