Transcend DrivePro 20 - Recording Videos; Normal Video Recording Settings; Emergency Recording and G-Sensor

4. Recording Videos
4-1 Normal Recording
By default, one video file is saved for every 1 minute of recording. To adjust the recording length, please
refer to the Settings section in this manual. When DrivePro 20 is fully charged, recording in 1080/60fps
can last for 2.5 hours, while recording in 1080/30fps can last 3 hours. The actual recording time differs
according to the recording condition.
When the DrivePro is idle for 5 minutes, power saving mode will be activated. The DrivePro will be turned
off automatically after another 5 minutes.
4-2 Emergency Recording
30% of the storage space will be saved for emergency video files. Video files recorded in emergency
mode are protected from being overwritten.
Automatic Emergency Recording:
During video recording, the DrivePro will automatically activate Emergency Recording mode when
detecting a collision. G-Sensor sensitivity can be adjusted or disabled in the Settings menu.
NOTE
If the G-Sensor sensitivity is set to “High”, even minor shocks will activate Emergency
Recording mode.
If the G-Sensor sensitivity is set to “Low”, only significant shocks will activate Emergency
Recording mode.
In the Power Saving Mode, recording is off.
