Transcension LED Master 64 - Delete Saved Colours; Program Chase Sequences

LED Master 64 manual
8
blinking, indicating that it has stored successfully (when the LED
indicator is off, this means there is no colour saved).
7 Repeat steps 2-6 to store more saved colours.
8 Hold PROGRAM/REC button for 3 seconds to exit programming mode,
the LED indicator above PROGRAM/REC will go off.
4.3 Delete Saved Colors
1 Enter programming mode.
2 Use UP/DOWN button to choose bank 1-6 to save the colour into
(Jump this step if you have chosen bank before).
3 Hold DEL/CLEAR button, press SAVED COLOURS 1-6,
all LEDs will blink 3 times and then go out, the corresponding
LED will then go off, indicating the saved colour has been
deleted successfully.
4 Repeat 2-3 steps to delete more colour presets.
5 Hold PROGRAM/REC button for 3 seconds to exit programming
mode, the LED above PROGRAM/REC button will go off.
4.4 Program Chase
1 Enter programming mode.
2 Press CHASE 1-8 button to choose chase
which you want to store in.
3 Press FIXTURE SELECTOR 1-8 button to choose units,
using fader 1-8 to adjust the light effect, or open a
previously saved colour.