TransCore Encompass 1150 User Manual

Trusted Transportation Solutions
16-1150-004 Rev E 7/2020
Encompass® 1150
Mobile Reader
TransCore’s Encompass 1150 (E1150) Mobile RFID Reader oers a portable and cost
eective solution for decoding or verifying RFID tags. The lightweight, ergonomic
design makes it the ideal choice for parking, tolling, railroad, ground management,
transportation asset management, field service, and warehouse operations.
This document describes the procedures to set up and use an Encompass 1150 (E1150) Mobile Reader.
Caution: Do not open the E1150 case. Opening the case will damage and disable the unit and
void the warranty.
Required Supplies
You need the following additional materials and/or tools to complete the reader installation:
• Host PC using Windows 2000 or newer operating system with at least one USB port
• USB communications cable provided with E1150
• USB wall charger provided with E1150
• USB drive with Field Configuration Software (FCSW)
• Test tag provided with E1150

TransCore Encompass 1150 Specifications

General

Frequency	902-928 MHz
Power Source	External power supply
Interface	RS-232, RS-485, Ethernet
Air Interface Protocol	EPCglobal UHF Class 1 Gen 2 / ISO 18000-6C
Protocol	EPCglobal UHF Class 1 Gen 2 / ISO 18000-6C
Power Output	1 Watt

Summary

Required Supplies for E1150 Installation

Installing and Setting Up the E1150 Software

Install Field Configuration Software

Install the FCSW software, creating desktop shortcuts for the software and instructions.

E1150 Setup Procedures

Connect the E1150 to a power source and host PC, ensuring proper charging and detection.

Launch FCSW Application and Connect

Launch the FCSW application and establish a connection with the E1150 reader via COM port.

Configure E1150 Operation Parameters

Reading Tags with the E1150

Advanced Reader Operations

Bluetooth Connectivity Setup

Establish a wireless virtual COM port connection using a USB Bluetooth adapter.

Host Data Logging Configuration

Enable saving tag reads to a log file on the host computer for later analysis.

Onboard Tag Buffering Activation

Utilize the E1150's internal memory to buffer tag reads, limited to a specified number of tags.

Disconnecting and Updating the E1150

Proper E1150 Disconnection Procedure

Safely disconnect the E1150 from the host PC by first exiting the FCSW software.

Firmware Update Process

Update the E1150 firmware using an official file via the FCSW Options tab.

E1150 Mobile Reader Diagnostics

Regulatory and Compliance Information