Transition Networks SGFEB 10/100/1000 Bridging Media Converter User Guide
33601 Rev. D www.transition.com Page 6 of 25
One DIP Switch Layouts
This layout has one six-position DIP Switch. The DIP switch is located on the right side of the SGFEB.
Use a small, flat-blade screwdriver (or a similar device) to set the DIP switches according to your site
requirements.
A. 6-Position DIP switch:
1 - Twisted Pair Port (Port 2) Autonegotiation: Up = Enabled, Down = Disabled.
2 - Twisted Pair Port (Port 2) Speed: Up = 100Mbps, Down = 10Mbps (only for Autoneg disabled).
3 - Twisted Pair Port (Port 2) Duplex: Up = Full, Down = Half (only for Autoneg disabled).
4 - Link Pass Through (LPT) Up = Disabled, Down = Enabled) (TX to FX and FX to TX).
5, 6 SFP Port control: these DIP switch settings have no affect on fixed optics models.
To Next Page
Loading...
