TP-701 / TP-701P Q&A
Confidential TO: FROMM HOLDING AG
Page 22 of 23 8/19/2008
7. The screws (HSS0506N) on the Actuator Lever are loose or stuck by Accumulator Box
Cover (T7-3-10110), so the Balance Bar (T7-3-10140) doesn’t work.
8. M4 Motor (T7-3-20211) is broken or poor connected.
9. The Pin (T7-2-10210) in Bandway is too close to the Arch, so the strap hit the Pin when
doing feeding. Adjust the Pin to about 15mm from the Arch.
T7-3-10140
T7-3-10110
HSS0506N
T7-3-10160
T7-3-20211
Connector
15mm
T7-5-10610
T7-2-10210
To Next Page
Loading...
