Transpak TP-201 - After Completing One Strapping Cycle, the Machine Continues Feeding Strap; Motor will Not Stop after the Preset Shut-Off Time; Motor Stops Running; Machine Shuts off Suddenly in the Middle of a Cycle

Semi-Auto Strapping Machine TP-201/202/203/202L
Q&A
Confidential TO: FROMM HOLDING AG Page 4 of 7 8/19/2008
(g) Clearance “A”{refers to the drawing(a)} between feed rollers is too small so that the
strap is reversed outside of the rollersTB-117. As a result, the strap can not be fed
out.
(h) Check if TF-006 Micro Switch (LS-3) is defective or connecting wire is loose.
VII. After completing one strapping cycle, the machine continues feeding strap
(a) Check if TG-002 Variable Resistor is defective or connecting wire is loose.
(b) Replace TG-007 PC Board.
(c) Check if the connection point of TG-005 Push Button Switch (L) is in a proper
condition
VIII. Motor will not stop after the preset shut-off time
(a) Check if TF-006 Micro Switch (LS-3) is defective or connecting wire is loose.
(b) Check if the TG-002 Variable Resistor of motor timer is defective or connecting wire is
loose.
(c) Replace TG-007 PC Board.
IX. Motor stops running
(a) Check if T6-6-30133 or T6-5-30034 Fuse is blown.
(b) Check if TF-043 Start Capacitor is defective or connecting wire is loose.
(c) Check if TF-042 Centrifugal Switch is defective or connecting wire is loose.
(d) Check if TF-001 motor is defective or connecting wire is loose.
(e) Replace TG-007 PC Board.
X. Machine shuts off suddenly in the middle of a cycle
(a) Replace blown T6-6-30133 or T6-6-30034 fuse.
(b) Replace TG-019 Power Cord.
(c) Replace TG-007 PC Board.
XI. Jammed or split strap
(a) Turn down the four nuts (no. 2 ) by 0.5 to 1.
(refer to the drawing on the right )