Transpak TP-201 - TA-080 Slide Does Not Return to Its Home Position; Reel Unit Does Not Brake and Strap Becomes Loose on the Reel; The TG-007 P.C.board Is Burnt

Semi-Auto Strapping Machine TP-201/202/203/202L
Q&A
Confidential TO: FROMM HOLDING AG Page 7 of 7 8/19/2008
XVIII. TA-080 Slide does not return to its home position
(a) Replace the TB-114 Spring of TA-090 Arm.
(b) Clean both sides of TA-080 Slide.
XIX. Reel unit does not brake and strap becomes loose on the reel
(a) Load the p.p. strap following the direction of arrow.
(b) Replace the TE-023 Rubber Stop (TP-201).
(c) Replace or Adjust the TC-018 Brake Lining (TP-202).
(d) Replace new TE-025(TP-201/TP-203) or TC-025(TP-202/TP-202L) Spring for the
brake if either one of them is worn.
XX. The TG-007 P.C.Board is burnt
(a) Check if the power supply is appropriate for the machine.
(b) Replace the TG-007 P.C.Board.
(c) Replace wires which have bad contact or are defective.
**All rights reserved**