EN
9
3.1 INSTALLING AND REPLACING THE BATTERIES (PIC. 2)
Slide o the battery cover.
Install the batteries by matching the correct polarity, as show pic. 2.
Always use the correct battery type (2 x AAa batteries).
Replace the battery cover.
3. BEFORE YOU START
3.2 SETTING DATE, TIME AND MEASUREMENT UNIT (PIC. 4)
It is important to set the clock before using your blood pressur moni-
tor, so that a time stamp can be assigned to each record that is stored in
the memory. (year: 2018 - 2058, time format: 12H/24H)
1. When the monitor is o, hold pressing “MEM” button for about 3
seconds to enter into setting mode. e blinking numeral represen-
ts [YEAR] (pic. 4.A)
2. Press the “MEM” button to change the [YEAR]. Each press will
increase the numeral by one in a cycling manner (pic. 4.B).
3. When you get the right year, press “START/STOP” button to
conrm your selection and it will turn to the next step (pic. 4.C)
(pic.4.D).
4. Repeat step 2 and 3 to conrm [MONTH] and [DAY]
5. (pic. 4.E) (pic. 4.F)
6. Repeat step 2 and 3 to conrm the time formate [12H] and [24H]
(pic. 4.G) (pic. 4.H)
7. Repeat step 2 and 3 to conrm [HOUR] and [MINUTE] (pic. 4.I)
Replace the batteries whenever the below happen
The shows
The display is dim.
The display does not light up
CAUTION
Do not use new and used batteries together.
Do not use different types of batteries together.
Do not dispose the batteries in fire. Batteries may explode or leak.
Remove batteries if the device is not likely to be used for some time.
Worn batteries are harmful to the environment. Do not dispose with daily garbage.
Remove the old batteries from the device following your local recycling guidelines.
To Next Page
Loading...
Need help?
General
