EN
10
3.3 TIE THE CUFF
1. Remove all accessories (watch, bracelet,etc) from your wrist. If your physician
has diagnosed you with poor circulation in your wrist, use the other one.
2. Roll or push up your sleeve to expose the skin.
3. Apply the cu to your wrist with your palm facing up.
4. Position the edge of the cu about 1cm~1.5cm from wrist joints.
5. Fasten the wrist cu around your wrist, leaving no extra room between the cu
and your skin. If the cu is too loose, the measurement will not be accurate.
6. Sit comfortably with your tested wrist resting on a at surface. Place your el-
bow on a table so that the cu is at the same level as your heart. Turn your palm
upwards. Sit upright in a chair, and take 5-6 deep breaths.
7. Patients with Hypertension: e middle of the cu should be at the level of the
right atrium of the heart; Before starting measurement, please sit comfortably
with legs uncrossed, feet at on the oor, back and wrist supported. Rest for 5
minutes before measuring.
Wait at least 3 minutes between measurements. is allows your blood circulation to
recover. Take the measurement in a silent room. e patient must relax as much as
possible and do not move and talk during the measurement procedure.
e cu should maintain at the same level as the right
atrium of the heart. Do not cross your legs and keep your
feet on the ground. Keep your back against the backrest of
the chair. For a meaningful comparison, try to measure
under similar conditions. For example, take daily mea-
surements at approximately the same time, on the same
wrist, or as directed by a physician.
3.4. START THE MEASUREMENT
1. When the monitor is o, press “START/STOP” button to turn on
the monitor, and it will nish the whole measurement (pic. 5.A)
(pic. 5.B).
2. Press “START/STOP” button to power o, otherwise it will turn o
within 1 minute (pic. 5.C) (pic. 5.D).
DATA MANAGEMENT
4.1 RECALL THE RECORDS
1. When the monitor is o, press “MEM” button to show the average
value of the latest three measurement records.If the records are
less than 3 groups,it will display the latest record instead (pic. 6. A).
2. Press “MEM” button again, it will display the latest measurement
result, date and time. Press “MEM” button again, it will display the
To Next Page
Loading...
Need help?
General
