EN
17
12. EMC Guidance
1)is product needs special precautions regarding EMC and needs to
be installed and put into service according to the EMC information pro-
vided,
and this unit can be aected by portable and mobile RF communications
equipment.
2)* Do not use a mobile phone or other devices that emit electromagnetic
elds, near the unit. is may result in incorrect operation of the unit.
3)Caution: is unit has been thoroughly tested and inspected to assure
proper performance and operation!
4)* Caution: is machine should not be used adjacent to or stacked with
other equipment and that if adjacent or stacked use is necessary, this ma-
chine should be observed to verify normal operation in the conguration
in which it will be used.
Table 1
Guidance and manufacturer’s declaration – electromagnetic emissions
RF emissions
CISPR 11
Group 1
Class B
Class A
Complies
Compliance
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
RF emissions
CISPR 11
Emissions test Electromagnetic environment - guidance
The device is intended for use in the electromagnetic environment specified below. The customer or the
user of the device should assure that it is used in such an environment.
The device uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in nearby
electronic equipment.
The device is suitable for use in all establishments,
other than domestic and those directly connected to
the public low-voltage power supply network that
supplies buildings used for domestic purposes.
To Next Page
Loading...
Need help?
General
