Set the User ID
BEFORE YOU START
7.After confirming the measurement
unit, the LCD will display “dOnE” and
then the monitor will turn off.
Before you start the measurement,
please set your desired user ID.
1.When the blood pressure monitor
is off, hold press “START/STOP”
button and then the user ID shows.
Then press “MEM” button to switch
the user ID between user A, user B
and Guest mode.
2.Press “START/STOP” button
to confirm user ID , the display
will show “User ID + dOnE” and
then the monitor will turn off.
BEFORE YOU START
To Next Page
Loading...
Need help?
General
