TRANSTEK TMB-2085 - Data Management Features; Deleting Measurement Records


ABOUT BLOOD PRESSURE
If you did not get the correct measurement, you can delete all results
by following steps below.
Deleting the Records
DATA MANAGEMENT
Note: To exit delete
mode, press START/STOP
button before pressing MEM
button to confirm any delete
commands.
3.If there is no record, no
numbers will show.
1. When it is in the memory mode,
hold pressing “START/STOP”
button for 3 seconds, it will
display “dEL ALL”+User ID.
2. Press “MEM” button to confirm
deleting, the LCD will display
“dEL dOnE” + User ID and then
turn off.
The most recent record (1) is shown first. Each new measurement is assigned
to the first (1) record. All other records are pushed back one digit (e.g., 2 becomes
3, and so on), and the last record (120) is dropped from the list.
CAUTION
Date and time will
display alternately.
The corresponding
time is 9:00.
The corresponding
date is 1st January.
2.
Press MEM button to get the record
you want.
mmHg
The corresponding
year is 2020.
DATA MANAGEMENT