How to Recharge the Spool
Recharging the spool is a quick and easy
procedure. Use only 2.4 mm gauge nylon
filament. Out of specification nylon filaments can
damage the motor, the spool running system and
consequently you'll loose the warranty.
1. Loosen the spool-mounting butterfly.
2. Remove the spool.
3. Put the nylon filament in the spool case
winding it clockwise.
4. When you have finished winding the nylon
filament, run it through the mounting
grooving to keep it from unwinding.
5. Assemble the spool back again, running the
nylon filament through the side holes.
6. Use the butterfly to mount the spool on the
equipment.
To Next Page
Loading...
