ENGLISH
27
www.trapp.com.br
Attention!
Frequently check if all screws are well
tightened, mainly the counter cutting
blade one. Always keep the counter
cutting blade adjusted to assure the good
performance of the shredder.
Check the status of the power supply cord. Never x
it with insulating tape.
Never use a water jet to clean the equipment. Water
inside the equipment can damage the electric circuit
of the motor, besides increasing the risk of an electric
shock. Use a cloth soaked in neutral detergent.
Clean the cutting assembly at each operation to avoid
material buildup on the disk shaft and hammers.
Never operate the shredder with the cover open or
without the belt protection guard.
In any abnormal situation during operation, turn
off the Ensiling and contact a TRAPP Technical
Assistant.
Image merely illustrative
Attention!
When the shredder is operating, do neither
put your hand inside the green crop feeder
nor in the outlet device.
Attention!
Whenever cleaning or servicing, make
sure the equipment is off and the blades
are still as they continue to move for some
seconds.
To Next Page
Loading...
