TRAPP ES-500 - Useful Suggestions

ENGLISH
44
www.trapp.com.br
Useful Suggestions
Throghout the use of the shredder situations and or problems may occur, for which we present some
suggestions:
Trouble Probable cause Solution
Shredder jamming
Excessive intake/feeding.
Due to this the motor can not
maintain necessary rotation,
and the material accumulates
inside the shredder. Use under
this condition may cause
motor to overload.
Turn off shredder and wait for motor to come to a full
stop. Open the lid, remove excess material, close lid,
turn on shredder, wait for motor to reach maximum
rotation and restart work. Control intake/feeding
according to motor's capacity.
Low production Insufcient feeding of shredder.
Maintain a continuous feeding flow, yet not over-feeding
which may cause the shredder to jam.
Irregular cut
1. Cutting blades need
sharpening.
2. Counter cutting blade
worn or not regulated
properly.
3. Insufcient feeding of
cylinder feeder.
1. Sharpen cutting blades as indicated in
Maintenance (page 40).
2. Proceed as indicated on page 41 Maintenance of
Counter Cutting Blade.
3. Increase the tension of cylinder spring (see page
39). Substitute upper cylinder if worn.
Trouble starting motor
1. Excessive intake of
product in shredder.
2. Electrical shortage.
1. Once work is nished, always leave shredder
working for a few extract minutes to allow all
material to exit.
2. Check condition of electrical power source.