36 Optional Equipment
© Travis Industries 100-01273 4150514
GreenStart
TM
Igniter – Firebrick and Housing Installation
This insert is compatible with the GreenStart
TM
automatic wood-stove igniter. This optional component
uses a specialized firebrick and housing that are shipped with the insert. If you are using the igniter, install
these components as shown below. The igniter is installed as shown in the instructions included with the
igniter kit.
Igniter Firebrick Igniter Housing
HINT: If you are not using the igniter, store these components inside the fireplace cavity in case the
homeowner later decides to install them.
1. Remove the two firebricks from the front left corner of the firebox.
2. Place the igniter firebrick as shown below.
To Next Page