Trek SUPERCALIBER SL - IsoStrut Maintenance Procedures; Remove IsoStrut; Add Oil to IsoStrut; Air Volume Spacers

2024 Supercaliber
13
IsoStrut maintenance
For detailed service instructions, refer to the RockShox SIDLuxe IsoStrut service manual found on SRAM’s dealer portal.
Remove the IsoStrut
1. Remove the IsoStrut mounting fasteners. See on
page 6.
1. Remove the damper components. See IsoStrut on
page 12.
2. Slide the IsoStrut from the carriage.
Add oil
1. Remove the spacer and oil plug. See IsoStrut on page
12.
2. Use a syringe to ll the IsoStrut with 15cc of Maxima
Suspension Plush Fluid 10WT — 600297.
3. Press the oil plug with spacer back into the IsoStrut.
4. Install the IsoStrut mounting fasteners. See on page
6.
Air volume spacers (bottomless tokens)
— 5316700
Two bottomless tokens are included with your Supercali-
ber. See the RockShox SIDLuxe IsoStrut service manual
found on the SRAM.com dealer portal for installation
instructions.
Install the IsoStrut
1. Use Maxima Suspension Plush Fluid 10WT — 600297
to lightly oil the inside of the carriage seals.
2. With the sag o-ring in place on the IsoStrut, insert the
IsoStrut into the carriage.
3. Install the damper components. See IsoStrut on page
12.
4. Install the IsoStrut mounting fasteners. See on page
6.