12 IQView8 Touch Screen Display Data Sheet TA201232 Issue 2, 10-Jul-2012
IQView8 Data Sheet
COMPATIBILITY
The IQView8 can connect to a single Trend site. It will show any
device, and identify those who respond to W comms. Autodialled
Lans and remote Ethernet sites cannot be accessed.
Controllers: IQView8 is compatible with IQ1xx controllers
version 6.5 and above and all IQ2xx, IQ3, IQ4, IQeco, and IQL
controllers. FNC/FC controllers are not supported.
Alarms: IQView8 supports general, item, critical, and network
alarms from devices on the network. It supports alarms
retransmitted from 962/963, however alarms retransmitted from
earlier supervisors (e.g. 945) are not supported. IP alarms from
IQ3 and IQ4 controllers are not supported.
NKSV and BBUF notications are ignored.
Timezones: IQView8 can view and adjust the operating
times in IQ1, IQ2, IQ3 and IQ4 controllers. For IQ1 and IQ2
controllers it can adjust the standard and current weeks, and
when supported by the controller set up and adjust the Holiday
Calendar times. For IQ3 and IQ4 controllers it can adjust the
normal week, and set up and adjust the exception times.
IQView8 will not discover modules without labels.
Plots: IQView8 supports synchronised, triggered, and periodic
plots.
Supervisors/Tools: IQView8 will be learnt by SET, and 963
and appear in the navigation tree.
Network connection: IQView8 supports connection to the
Trend network using Ethernet, current loop Lan, or RS232 to
suitable a network node.
Schematics: IQView8 supports schematic pages exported
from 963 using the 96x Schematic Export Utility. See the 96x
Schematic Export Utility Manual (TE201242) for a full list of
supported 963 actions.
GraphIQs: It supports the display of GraphIQs from IQ3 and
IQ4 controllers. The ‘clickable’ action available on GraphIQs
is not supported by IQView8. This means that links to module
detail pages, module type pages, web pages, other GraphIQs
and email will not work.
To Next Page
Loading...
