© Copyright 2012 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-659BRV
2
• Supports static and dynamic RIP v1/2 routing
• Dynamic DNS Client for dynamic Internet IP resolution
• Device monitoring using the Internal System Log, External Syslog, E-mail Alert,
and SNMPv1/2c
• Local/Remote management via Web browser, upgrade firmware, and
backup/restore configuration
• One-touch Wi-Fi Protected Setup (WPS) button connects wireless clients
quickly
• Complete wireless security with WPA/WPA2, WPA/WPA2-PSK, and WEP
*The number of supported concurrent VPN tunnels is dependent upon available bandwidth
**Maximum wireless signal rates are referenced from IEEE 802.11 theoretical specifications.
Actual data throughput and coverage will vary depending on interference, network traffic,
building materials and other conditions.
Product Hardware Features
Rear Panel View
• LAN Ports – Connect Ethernet cables (also called network cables) from your
router LAN ports and to your wired network devices.
• WAN Port - Connect an Ethernet cable (also called network cable) from your
router WAN port and to your xDSL/Cable modem.
• Power Port – Connect the included power adapter from your router power
port and to an available power outlet.
Note: Use only the adapter that came with your router.
• On/Off Power Switch – Push your router On/Off push button power switch to
turn your router “On” (Inner position) or “Off” (Outer position).
• Antennas – The antennas broadcasts wireless signals to allow your wireless
clients and wireless network devices to connect to your router.
To Next Page
Loading...
Need help?
General
