EasyManua.ls Logo

TRENDnet TEW-659BRV - Technical Specifications

TRENDnet TEW-659BRV
97 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© Copyright 2012 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-659BRV
80
Technical Specifications
Hardware
Standards IEEE 802.3 (10BASE-T), IEEE 802.3u (100BASE-TX), IEEE 802.11b/g/n
WAN 1 x 10/100Mbps Auto-MDIX port (Internet)
LAN 4 x 10/100Mbps Auto-MDIX ports
Power Switch On/Off power switch
WPS/Reset
Button
Wi-Fi Protected Setup (WPS) - Automated wireless connection push button (Hold for 3
seconds)
Reset button - Factory Default (Hold for 20 seconds)
Connection Type Dynamic IP, Static (fixed) IP, PPPoE, PPTP, L2TP
Firewall NAT, SPI, and DoS prevention
VPN
IPsec/PPTP/L2TP– Up to 80* tunnels
PPTP/L2TP Server and Client – Define up to 5 user accounts each (multiple logins per
account)
IPsec/L2TP/PPTP VPN pass through – Up to 100 sessions
GRE – Up to 8 tunnels
IPsec VPN
Protocols
Encryption (DES, 3DES, AES-128/192/256 bit), Authentication (MD5, SHA1), DH/PFS
Groups (1-18), Key Management (Manual/IKE), Preshared Key (PSK), Encapsulation (ESP,
AH, ESP+AH), Mode (Main/Aggressive), NAT Traversal, NetBIOS over IPsec, XAUTH, Keep-
Alive, Dead Peer Detection (DPD), Local/Remote ID (FQDN, E-Mail, Key ID)
PPTP/L2TP VPN
Protocols
Authentication (PAP, CHAP, MS-CHAP v1/2), Encryption (MPPE-40/56/128 bit)
Access Control
Virtual Servers, Packet MAC/IP Packet Filters, URL/Keyword Filters, DMZ host, One-to-
One NAT, UPnP, and IGMPv1/2 pass through
Time/Schedule
Set time via NTP or manually and define schedules: wireless, virtual server, packet filters,
and QoS
Routing Static and Dynamic RIP v1/2
Quality of
Service
Service-Based IP/(TCP/UDP) port with 3 priority queues (High, Normal, Low), and WMM
Management/
Monitoring
Local/remote configuration, upgrade firmware, Backup/Restore configuration via Web
browser, Internal System Log, Syslog, E-Mail Alert, SNMPv1/v2c, Ping Test Tool, and
Wake-on-LAN (WoL)
LED Indicator Status, LAN1~LAN4, WAN (Internet), WLAN/WPS
Power Adapter 12V DC, 1A external power adapter
Power
Consumption
5.4 Watts (max.)
Dimension (L x
W x H)
189 x 118 x 33 mm (7.4 x 4.6 x 1.3 in)
Weight 272 g (9.6 oz)
Temperature
Operation: 0°~ 40°C (32°F~ 104°F); Storage: -10°~ 90°C (14°F~158 °F)
Humidity Max. 95% (non-condensing)
Certifications CE, FCC
Wireless
Frequency 2.412 ~ 2.472 GHz
Access Point
Modes
Access Point (AP) and Wireless Distribution System (WDS)
SSID Broadcast up to 4 SSIDs each with different wireless security
Security 64/128-Bit WEP (HEX & ASCII), WPA/WPA2 RADIUS, WPA/WPA2-PSK
Antenna 2 x 2 dBi fixed antennas
Modulation DSSS, BPSK, QPSK, DBPSK, DQPSK, CCK, OFDM (BPSK/QPSK/16QAM/64QAM)
Data Rate
802.11b: up to 11Mbps
802.11g: up to 54Mbps
802.11n: up to 300Mbps**
Output Power
802.11b: 17dBm (typical)
802.11g: 14dBm (typical)
802.11n: 12dBm (typical)
Receiving
Sensitivity
802.11b: -84dBm (typical) @ 11Mbps
802.11g: -72dBm (typical) @ 54Mbps
802.11n: -66dBm (typical) @ 300Mbps
Channels 1~ 11 (FCC), 1~13 (ETSI)
*The number of supported concurrent VPN tunnels is dependent upon available bandwidth
**Maximum wireless signal rates are referenced from IEEE 802.11 theoretical specifications. Actual
data throughput and coverage will vary depending on interference, network traffic, building materials
and other conditions.

Table of Contents