DSCP: Select the DSCP value to apply
Source/Destination MAC Address: Enter the source and destination MAC address
of the rule.
Generic Rules
1. To create a new rule. Click Add in the Rules section.
2. Review the settings and click Apply to save.
Filter Name: Select the filter name to apply the rule. Enter the name of the filter.
Enable: Check to enable rule
Type: Select the value type to apply on the rule.
Proto: Select the IP Protocol data type
Position: Specify the location of the packet location
Condition: Select the condition type of the rule
Value: Enter the IP checksum value of the packet
Action: Select the action to take of the rule.
Advanced Router Setup
Access your router management page
Note: Your router management page http://192.168.10.1 is accessed through the use of
your Internet web browser (e.g. Internet Explorer, Firefox, Chrome, Safari, Opera) and
will be referenced frequently in this User’s Guide.
1. Open your web browser (e.g. Internet Explorer, Firefox, Safari, Chrome, or Opera)
and go to http://192.168.10.1. Your router will prompt you for a user name and
password.
2. Enter the default user name and password and then click Login.
Default User Name: admin
Default Password: xxxxxxxxxx
To Next Page
Loading...
Need help?
General
