IDENTIFICATION DATA
For technical assistance or to request replacement parts, always give the model, the version and serial number written on the serial number
plate.
TECHNICAL DESCRIPTION
INTENDED USE
SAFETY
SERIAL NUMBER PLATE
This appliance has been built for the professional cleaning of indoor hard vinyl oors, to be carried out by following the instructions. The
appliance must only be used for this purpose.
This appliance was designed and built to be used by a qualied
operator to clean smooth, compact ooring in the commercial,
residential and industrial sectors, in proven safety conditions. The
machine is suitable for carpet oor cleaning if used with proper
accessories. The appliance is only suitable for use in indoor - or at
least covered - areas.
Operator cooperation is paramount for accident prevention. No
accident prevention programme can be effective without the full
co-operation of the operator who is directly responsible for machine
operation. The majority of occupational accidents that happen both
in the workplace or whilst moving are caused by failure to respect
The serial number plate is located at the rear of the handlebar, and
indicates the general characteristics of the appliance, in particular
the appliance's serial number. The serial number is a very important
piece of information and should always be provided together with any
request for assistance or when purchasing spare parts.
ATTENTION: The appliance is not suitable for use in the rain,
or under jets of water.
the most basic safety rules. An attentive, careful operator is most
effective guarantee against accidents and is fundamental in order to
implement any prevention programme.
66
6
TECHNICAL DATA U/M TRIDENT FMD20
ORBITAL
Working width in 20
Pad holder diameter in 20
Engine speed Rot./min. 1400
Number of orbits dragging disc Orb./min. 1400
Brush head motor rated power W 1100
Brush head motor nominal voltage V 120
Brush head motor frequency Hz 50 / 60
Maximum gradient with full load % 2
Solution tank capacity (optional) gal 3,96
Rear wheels (diameter / width) in 7.9 - 1.8
Appliance length in 30,1
height of the appliance to the brush head carter in 12,6
Height of the appliance to the shaft in 48
Appliance width in 21,25
Appliance service weight (without solution tank) Lb 154,3
Length of power supply cable yd 16,4
To Next Page
Loading...