Trigon Electronics Minipak - Programming: Voice Messages; Recording Voice Message; Auto Message Disable Function

To Next Page

To Previous Page

Page 10

Minipak

(P) Auto Message Disable:(P) Auto Message Disable:

(P) Auto Message Disable:

To disable the Auto Message function, set the Site

Identification code to 0000.

1. The unit must be in Program Mode.

2. Press '#8' then '0000' to Disable voice module

completely.

You will hear two beeps.

3. If desired, exit Program Mode by pressing '#'

(wait for two second tone).

4. To terminate call, press '7'.

(O) Recording a new voice message.(O) Recording a new voice message.

(O) Recording a new voice message.

To change the voice message on the voice chip

follow these steps:

1. Referring to Page 5, move jumpers W1, W3,

and W4 from the out board pair to the inboard

pair.

2. To record a message press the "REC" button

and speak into the microphone on the front of the

panel. Message can be up to 15 seconds.

3. To play back the message press the play button

and the message will play through the speaker.

To re-record the message just push the REC

button again.

4. If the play back is satisfactory, re position the

W1, W3, and W4 jumpers to their out board

positions.

PROGRAMMINGPROGRAMMING

PROGRAMMING

Other manuals for Trigon Electronics Minipak