Trinity XPERT-PRO - Resetting Demand Power

XPERT-PRO – Operational Manual
TRINITY
[18]
1. In Run Mode, press key for about five seconds and then the unit displays
the first programmable parameter, DEMAND ON. Press key several times
to retrieve the programmable parameter, RESET ENERGY such as shown
below.
2. Press key again. Immediately ‘P’ starts blinking which shows that the
parameter can now be selected. Set the RESET ENERGY to YES by pressing
or keys and then press key to reset all energy parameter.
3. To retrieve to the next desired parameters, press key so as to set as
before. Or else, press key for about five seconds to return into Run Mode.
Resetting Demand Power
Both KW_D and KVA_D can be reset with their maximum Demand Power (MAX
DMD). In case, Demand Power is set to YES, both the Demand Powers including
Maximum Demand will be replaced by zeroes in Run Mode.
To select the Reset Demand, precede the following instructions.
1. In Run Mode, press key for about five seconds and then the unit will
display the first programmable parameter, DEMAND ON. Press key
several times to retrieve the programmable parameter, RESET DEMAND
such as shown below.
2. Press key again. Immediately ‘P’ starts blinking which shows that the
parameter can now be selected. Set RESET DEMAND to YES by pressing
or keys and then press key to reset all Demand parameter.
3. To retrieve to the next desired parameters, press key so as to set as
before. Or else, press key for about five seconds to return into Run Mode
If your setting is completed.
RESET
DEMAND
YES?
RESET
ENERGY
YES?