Survey Pro Reference Manual
R-136
3.
To prevent errors if this button is used, the backsight set up
is invalidated when exiting the Stakeout
dialog. A circle
zeroed on a design point is meaningless once the design point
has been staked.
Note: The
&LUFOH =HUR
button is not available when using a robotic
total station.
%DFN
: returns to the previous screen.
6WDNH !
: accesses the fourth Stake Line and Offset
screen, which is
identical to the third Stake Points screen, described on Page R-114.
Note: Tap the graphic portion of the screen for an expanded view.
Screen Summary
Screen One is used to define the primary line used to determine the
location of the line to be staked and the station associated with the
Start Point.
Screen Two is used to define the offset distance and location, the
station to be staked and the station interval.
Screen Three provides the distance and direction information to the
current station to be staked.
Screen Four is used to stake the current station.
To Next Page
