J
joneselijahSep 13, 2025
What to do if the Tripp Lite SmartOnline SU10KRT3/1X fault LED is on due to Er16/Er27?
- MMelinda BrownSep 13, 2025
All parallel UPS parameters except ID number must be the same. Adjust the parameters.
To Next PageTo Next PageWhat to do if the Tripp Lite SmartOnline SU10KRT3/1X fault LED is on due to Er16/Er27?
All parallel UPS parameters except ID number must be the same. Adjust the parameters.
General| Brand | Tripp Lite |
|---|---|
| Model | SmartOnline SU10KRT3/1X |
| Category | UPS |
| Language | English |
Warnings about where to install the UPS for safe operation and optimal performance.
Critical warnings regarding electrical connections and user safety during installation.
Essential safety precautions and guidelines for electrical wiring of the UPS system.
Safety precautions and handling instructions for UPS batteries to prevent injury and damage.
Explanation of symbols found on the product label for identification.
Identifies and describes the ports and connectors on the rear of the UPS power module.
Instructions for unpacking the UPS system and checking the packing list.
Details the components included in the UPS system hardware kit for installation.
Guidance on selecting an appropriate location for the UPS system to ensure optimal performance.
Detailed procedure for mounting the UPS system in a 4-post rack or enclosure.
Instructions for mounting the UPS system in an upright, tower configuration.
Steps to prepare for wiring, including de-energizing and marking cables.
Illustrates the terminal block layout for AC input and output connections.
Provides specifications for AC input/output wiring, including current, diameter, and torque.
Step-by-step instructions for connecting AC input and output wiring.
Procedure for connecting an external battery pack to the UPS system.
Overview of control panel, buttons, LEDs, LCD symbols, and error codes for operation.
Step-by-step guide for starting the UPS system in normal operating mode.
Instructions for starting the UPS from battery power when AC input is unavailable.
Procedures for safely shutting down the UPS system and its output.
How to check measurements, access settings, and change defaults.
Lists parallel kit components and guidelines for UPS system placement.
Procedure for installing and starting up UPS systems in parallel mode.
Information about the internal network card for remote monitoring and control.
How to use EPO and connect via RS-232 serial port for monitoring.
Table listing common problems, error codes, and possible solutions for the UPS system.
How to handle errors detected during the UPS self-test procedure.
Technical specifications for the UPS input and output power requirements.
Physical dimensions and weight of the UPS power module.
Guidelines for storing the UPS system to maintain battery health.
Information on warranty, service options, and contacting support.
Terms and conditions of the product's limited warranty.
Information on compliance numbers and product identification.
