To Next PageTo Next Page
Need help?Do you have a question about the Tripp Lite SmartPro SMC10002URM and is the answer not in the manual?
General| Type | Line-interactive |
|---|---|
| Nominal Input Voltage | 120V |
| Input Voltage | 120V |
| Nominal Output Voltage | 120V |
| Output Voltage | 120V |
| Output Voltage Regulation | +/- 5% |
| Waveform Type | Sine wave |
| Transfer Time | 4 ms |
| Number of Outlets | 8 |
| Outlets | 8 x NEMA 5-15R |
| Form Factor | Rackmount |
| Form Factor (Rack Units) | 2U |
| Runtime (half load) | 15 minutes |
| Typical Recharge Time | 8 hours |
| Output Power Capacity | 1000 VA |
| Output Power Capacity (Watts) | 900 W |
| Frequency | 50 / 60 Hz |
| Battery Type | Sealed Lead-Acid (SLA) |
| Communication Ports | USB, Serial |
| Network management | Optional network management card slot |
Guidelines for UPS placement, connection, and equipment connection to ensure safe operation.
Precautions for battery handling, replacement, disposal, and recycling procedures.
Steps to plug in the UPS, connect equipment, and turn on the unit.
Overview of the UPS LCD display and key operational buttons like ON/OFF, MODE.
Viewing input voltage, output voltage, runtime, load percentage, and battery capacity.
Step-by-step guide for safely replacing the UPS batteries.
