Programming Instructions
2
MicroIQ Electronic Lock Programming Guide
Lock Components and Features:
Programming Instructions
Pre-programmed Codes
Your keypad lock has come preprogrammed with two (2) codes:
Access Code 1-1-1-1-1 to allow access to the unit before you program
your own codes, and Factory Code 1-2-3-4-5 to allow you to program
your own unique Master Code. This Master Code does not give you
access to the unit; it is for programming only.
It is important to write down the new 5-digit Master Code in a
safe place and do not share it with anyone. Please make note of
your new Master Code here before you begin the programming
procedure.
Note: Refer to page 1 where you recorded your Master Code.
Do not give your Master Code to anyone. If the Master Code is
compromised, then the unit’s security is compromised.
Green
Proceed
LED
Red
Error
LED
Yellow
Low battery
LED
Knob
in locked
position
Location to
point the
key-fob
Battery
holder
with cover
Keypad
Program
button
Push thin
front edge
inward
Press
Here
To Next Page
Loading...