TriTeq MicroIQ UM - Available User Ids; Operating the Lock with an Access Code; Unlocking the Unit

Available User IDs
Use this chart to record Access Codes for each User ID. User ID #11
is factory-set to Access Code 1-1-1-1-1, and should be reprogrammed
first.
11 (1-1-1-1-1) 12 13 14 15
21 22 23 24 25
31 32 33 34 35
41 42 43 44 45
51 52 53 54 55
A total of twenty-five (25) codes can be programmed.
Programming Instructions
6
MicroIQ Electronic Lock Programming Guide
Unlocking the Unit
Warning: Three invalid attempts will cause the lock to block any
other attempts for 3 minutes.
To open the unit:
1. Enter the 5-digit Access Code.
If a valid 5-digit Access Code is entered, the green LED will light
up and the lock will unlock. Proceed to step 2.
If an invalid Access Code is entered, the red LED will flash 3
times.
2. Rotate the knob clockwise to the unlocked position.
The lock will re-engage within 5 seconds if left in the locked
position.
3. To relock, rotate the knob counter-clockwise to the locked
position.