TriTeq MicroIQ UM - Programming a New Master Code

To Next Page

To Previous Page

MicroIQ Electronic Lock Programming Guide

Programming a New Master Code

Warning: Do not set your Master Code to 1-2-3-4-5. Doing so will

erase all existing Access Codes and reset User ID 1-1 to

Access Code 1-1-1-1-1.

If a valid Master Code is entered, the green, red, and yellow

LEDs will ash.

If an invalid Master Code is entered, the red LED will ﬂash 3

times, and the keypad will exit programming.

Once the new Master Code is programmed, the 1-2-3-4-5 Factory

Code becomes invalid.

Note: All Access Codes remain the same when a new Master Code is

programmed.

1. With the lock in either unlocked or locked position, press and

The keypad will enter programming mode, and the green LED

will light up.

2. Enter your 5-digit Master Code

If the code is entered correctly, the green LED will light up.

Proceed to step 3.

If no code is entered within 10 seconds, or if the code is entered

incorrectly, then the red LED will ﬂash 3 times, and the keypad

will exit programming mode.

3. Press and hold the Program Button for 5 seconds.

The keypad will enter programming mode. The red LED will

ﬂash once, and then the green and yellow LEDs will light up.

4. Enter the desired 5-digit Master Code.

MY MASTER CODE: __ - __ - __ - __ - __

Programming Instructions

hold the Program Button

(located below the #3 button) for 5

seconds.