TERMS AND SYMBOLS USED IN THIS MANUAL
“Front of the Workcentre” refers to the end which has the switchbox. The “left-hand &
right-hand side” are when viewed from the front of the Workcentre.
Safety warning or safety instruction.
Handy hint & tip.
Possible fitting or operating difficulty.
Assembly & Operating Manual
A WORD FROM THE MANUFACTURERS
Thank you for your purchase of the Triton Series 2000 Workcentre. If properly set up,
and fitted with a good quality saw and blade, it will give you great accuracy and many
years of trouble-free service.
To set up properly, make sure you follow this manual. Otherwise you could spend
many unnecessary hours, and still not get it right.
Workcentre
Quality
Endorsed
Company
TABLESAW MODE
CROSSCUT MODE
Parts list 2 Test Cuts - Table saw mode 12-13
Basic assembly diagram 3 Test Cuts - Crosscut mode 13-14
Fitting the Triton Precision Saw
4-5 Operating - Table saw 15-23
Fitting other brands of saw 6-7 Operating - Crosscut saw 24-27
Final assembly 8-11 Warranty & Mailing List 28
To Next Page
Need help?
General
