14
• Any damage to the router should be
repaired and carefully inspected before
use, by qualified repair personnel. Service
or maintenance performed by unqualified
personnel could result in a risk of injury.
• Servicing should only be carried out
by authorised Triton Repair Centres
using original Triton replacement parts.
Follow instructions carefully and refer
to “Trouble-shooting” for problem
identification and advice. Use of
unauthorised or faulty parts may create a
risk of electric shock or injury.
• Triton Manufacturing & Design Co. will not
be responsible for any damage or injury
caused by unauthorised repair of the
router or by mishandling of the tool.
BRUSH REPLACEMENT
The carbon brushes are a consumable item
which should be inspected periodically and
replaced when worn. Failure to do so may
result in damage to the motor.
1. With the router disconnected from power,
unscrew the Brush Caps (8) located on
the front and rear of the motor.
2. Remove the brushes by pulling carefully on
the protruding springs.
3. If either of the
brushes is worn to
less than 6mm long,
they must both be
replaced using genuine
Triton replacement
brushes - available
from Authorised Triton Repair Centres.
POWER CORD REPLACEMENT
If the supply cord needs replacing, the
task must be carried out by the
manufacturer, the manufacturer’s agent,
or an authorised service centre in order
to avoid a safety hazard.
SERVICE
Service
To Next Page
Loading...
Need help?
General
