Triumph Adler 256i User Manual (English)

Questions and Answers:

S
Stephanie LeblancAug 20, 2025
Why Triumph Adler 256i All in One Printer cannot send fax?
- E
  Ethan GardnerAug 20, 2025
  There might be several reasons why your Triumph Adler All in One Printer is unable to send a fax. Ensure the modular cord is correctly connected. Verify that the Permitted FAX No. or Permitted ID No. are registered correctly. If a communication error occurred, check the error codes in the TX/RX Result Report and Activity Report, and perform the corresponding procedure if the error code starts with "U" or "E". The destination FAX line might be busy, or the destination FAX machine might not be responding, in which case you should try sending again. If none of these solutions work, contact your Service Representative.
R
Robert MossAug 22, 2025
What to do if my Triumph Adler 256i All in One Printer cannot send document?
- M
  megan32Aug 22, 2025
  If your Triumph Adler All in One Printer is unable to send a document, first ensure the modular cord is correctly connected. If a send error is displayed, remedy the cause of the error and try sending again. Also, check if TX (transmission) restriction is activated, and if so, cancel the TX restriction.
P
perezashleyAug 25, 2025
What to do if Triumph Adler 256i All in One Printer displays 'Add the following paper in cassette 1 (~3)'?
- E
  elijah39Aug 25, 2025
  This message on your Triumph Adler All in One Printer indicates that the indicated cassette is out of paper. Add paper to the cassette. If a specific reception paper type is required, it will also be displayed. To use a different paper source, press [Paper Selection]. To continue printing with the selected paper, press [Continue]. Alternatively, the cassette might not be securely loaded; remove the cassette and reload it completely. If the type of printing paper specified is unavailable, select another paper source and press [Continue].
J
Julia GrahamAug 26, 2025
What to do if my Triumph Adler All in One Printer cannot receive document?
- A
  April HowardAug 26, 2025
  If your Triumph Adler All in One Printer is unable to receive a document, ensure the modular cord is correctly connected. If a communication error is displayed, remedy the cause of the error and ask the sender to retry. Additionally, check if RX (reception) restriction is activated and cancel it if necessary.
C
Christian CarrilloAug 28, 2025
Why Triumph Adler 256i All in One Printer FAX connection could not be made?
- M
  Mr. Kevin Gibbs Jr.Aug 28, 2025
  A FAX connection on your Triumph Adler All in One Printer might fail for several reasons. Ensure the fax machine is turned on. Check if an error has occurred on the machine; if so, clear the error and attempt the transmission again. Also, verify that the IP address of the machine is correctly set in the Network FAX driver properties.
D
Dustin EdwardsAug 29, 2025
What does 'Box limit exceeded' mean on Triumph Adler 256i?
- E
  eric12Aug 30, 2025
  The 'Box limit exceeded' message on your Triumph Adler All in One Printer means: * The Sub Address Box capacity is full. Press [End] to cancel the job. Try again after printing or deleting data from the Sub Address Box. * The polling box is full. Press [End] to cancel the job. Delete documents from the polling box and repeat the operation.
C
cvargasAug 31, 2025
What to do if Triumph Adler 256i All in One Printer shows 'Job Accounting restriction exceeded'?
- P
  Patrick PrinceAug 31, 2025
  If your Triumph Adler All in One Printer displays 'Job Accounting restriction exceeded,' it means the number of pages used has surpassed the preset limit. No further operation is possible. Press [End] to cancel the current job. Try again after resetting the limit for paper use.
T
timothyfowlerSep 2, 2025
What does 'Machine failure' mean on Triumph Adler 256i All in One Printer?
- J
  Julie Brown MDSep 2, 2025
  If your Triumph Adler All in One Printer displays 'Machine failure', turn the main power switch off and on, or unplug the power cord and plug it in again. If the message persists, note the error code, turn the main power switch off, unplug the power cord, and call your service representative.
S
snydercrystalSep 4, 2025
Why Triumph Adler 256i shows 'Only one destination is available for FAX Polling RX. Enter the destination again'?
- J
  Jessica WhitakerSep 4, 2025
  This message on your Triumph Adler All in One Printer indicates that you specified multiple contacts for polling reception. Only one contact can be specified at a time for polling reception. Specify the contact again.
D
Daniel NelsonSep 6, 2025
Why Triumph Adler 256i All in One Printer cannot perform encrypted communication?
- K
  Kyle BradySep 6, 2025
  If your Triumph Adler All in One Printer cannot perform encrypted communication, double-check the registrations both at sender and recipient to ensure they are correct.