Triumph Explorer - Position Light; Front Fog Lights (if Fitted); Rear Light;Licence Plate Light; Direction Indicator Lights

Maintenance and Adjustment
172
Position Light
1. Fixings
2. Headlight surround
3. Position light bulb
The position lamp is fitted to the centre
of the headlight. To replace the bulb,
remove the four fixings and remove the
headlight surround, detach the rubber
retainer from the headlight and pull out
the bulb.
Installation is the reverse of the removal
procedure.
Front Fog Lights (if fitted)
The fog light units are sealed,
maintenance-free LED units.
Rear Light/Licence Plate Light
The rear light unit is a sealed,
maintenance-free LED unit. The licence
plate light is integral to the rear light
unit.
Direction Indicator Lights
1. Indicator lens
2. Securing screw
The lens on each indicator light is held in
place by a securing screw located in the
lens of the light.
Release the screw and remove the lens
to gain access to the bulb for
replacement.
LED Direction Indicator Lights
The LED direction indicator light units
are sealed, maintenance free LED units.
2
3
1
1
ch
g
n_1
celc_2
1
2