General Information
84
Traction Control Settings
The TC system can be disabled as
described in Bike Setup on page
50, or
set to the conditions described in Riding
Mode Configuration on page
62.
Tyre Pressure Monitoring
System (TPMS) (if fitted)
Function
Tyre pressure sensors are fitted to the
front and rear wheels. These sensors
measure the air pressure inside the tyre
and transmit pressure data to the
instruments. The sensors will not
transmit data until the motorcycle
reaches a speed of approximately
12 mph (20 km/h). Two dashes will be
visible in the system display until the
tyre pressure signal is received.
After bring the motorcycle to a stop, the
sensors continue to transmit data for
approximately seven minutes before
switching off. The tyre pressure values
remain visible in the system display until
the sensors switch off.
An adhesive label will be fitted to the
wheel rim to indicate the position of the
tyre pressure sensor, which is near the
valve.
Warning
If the traction control is disabled, the
motorcycle will handle as normal but
without traction control. In this
situation accelerating too hard on
wet/slippery road surfaces may cause
the rear wheel to slip, and may result
in loss of motorcycle control and an
accident.
Warning
The daily check of tyre pressures
must not be excluded because of the
fitment of the TPMS. Check the tyre
pressure when the tyres are cold and
using an accurate tyre pressure
gauge (see page
156).
Use of the TPMS system to set
inflation pressures may lead to
incorrect tyre pressures leading to
loss of motorcycle control and an
accident.
To Next Page
Loading...
Need help?
General
