Triumph XRX - Selecting a Riding Mode - When Riding the Motorcycle

General Information
48
With the Engine Off
• The ignition is switched ON
• The engine stop switch is in the RUN
position.
With the Engine Running
• Neutral gear is selected or the clutch
is pulled in.
Once the MAP, ABS and TTC settings
have changed, the selected riding mode
will be displayed and the previous mode
will no longer be visible.
1. Selected riding mode
Selecting a Riding Mode –
when Riding the Motorcycle
1
Warning
The selection of riding modes whilst
the motorcycle is in motion requires
the rider to allow the motorcycle to
coast (motorcycle moving, engine
running, throttle closed, clutch lever
pulled in and no brakes applied) for a
brief period of time.
Riding mode selection whilst the
motorcycle is in motion should only be
attempted:
• At low speed
• In traffic free areas
• On straight and level roads or
surfaces
• In good road and weather
conditions
• Where it is safe to allow the
motorcycle to briefly coast.
Riding mode selection whilst the
motorcycle is in motion MUST NOT be
attempted:
•At high speeds
• Whilst riding in traffic
• During cornering or on winding
roads or surfaces
• On steeply inclined roads or
surfaces
• In poor road/weather conditions
• Where it is unsafe to allow the
motorcycle to coast.
Failure to observe this important
warning will lead to loss of motorcycle
control and an accident.