General Information
59
Right Handlebar Switches
1. Engine stop switch
2. Starter button
3. Cruise control adjust button
4. Cruise control ON/OFF button
Engine Stop Switch
In addition to the ignition switch being
turned to the ON position, the engine
stop switch must be in the RUN position
for the motorcycle to operate.
The engine stop switch is for emergency
use. If an emergency arises which
requires the engine to be stopped, move
the engine stop switch to the STOP
position.
Note:
• Although the engine stop switch
stops the engine, it does not turn off
all the electrical circuits and may
cause difficulty in restarting the
engine due to a discharged battery.
Ordinarily, only the ignition switch
should be used to stop the engine.
Starter Button
The starter button operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the
handlebar.
Note:
• Even if the clutch lever is pulled to
the handlebar, the starter will not
operate if the side stand is down and
a gear is engaged.
Cruise Control ON/OFF Button
When the cruise control button is
pressed in, the cruise control is on (see
page 53). The button will remain in until
it is pressed again to turn off the cruise
control.
Cruise Control Adjust Button
The cruise control adjust button is a two
way switch with the top marked RES/+
and the bottom marked SET/- (see
page 54).
To Next Page
Loading...
