General Information
74
To adjust the handlebars, loosen and
remove the handlebar rear (8 mm
threaded) clamp fixings, and then the
front (10 mm threaded) clamp and riser
fixings.
1. 10 mm fixings
2. 8 mm fixings
Lift the handlebars out of the handlebar
risers and support with the aid of an
assistant.
Rotate both risers through 180° and
align the fixing holes.
Reposition the handlebars to the risers.
Refit the upper clamps, and secure with
the two 10 mm threaded fixings in the
rear fixing positions. Do not fully tighten
the fixings at this stage.
Rotate the handlebar so that the
alignment marking on the handlebar
aligns with the split line on the upper
clamps/risers.
1. Upper clamp
2. Clamp split line
3. Alignment marking
(Tiger XR
X shown)
Tighten the 10 mm fixings to 35 Nm.
Refit the 8 mm fixings to the front
positions and tighten to 26 Nm.
To Next Page
Loading...
