Trojan MULTIFUNTION SMITH MACHINE - Maintenance

58
MAINTENANCE
CLEANING
Clean the weight bench with a damp cloth and mild, non-abrasive detergent; do not use solvents.
Please inspect all assembly bolts and lock nuts on the machine for proper tightness before use.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight bench, can stretch slightly when it is rst used. If there is
slack in the cables before resistance is felt, the cables should be tightened. Make sure that the cables are not
too tight, or the weight carriage will be lifted. Slack can be removed in the following ways:
1. Remove the M10 x 50 mm Bolt (104) and the M10 Locknut (79)
attaching the lower 90 mm Pulley (58), the Plastic Cable Trap
(63), and the Half Guards (40) to the Pulley Plates (74).
2. Reattach the Pulley, Plastic Cable Trap, and Half Guards to the
next higher set of holes in the Pulley Plates with the Button
Bolt and the Locknut.
3. Repeat these actions until the cables are tight.
4. To loosen the cables, move the 90 mm
Pulley (58) to a lower hole in the Pulley Plates (74).
1. Remove the M10 x 50 mm Bolt (104) and the M10 Locknut (79)
attaching the 90 mm Pulley (58), the Plastic Cable Trap (63),
and the two Half Guards (40) to the U-bracket (47).
2. Reattach the Pulley, Plastic Cable Trap, and Half Guards to the
higher set of holes in the U-bracket with the Button Bolt and
the Locknut.
3. Tighten the M6 Locknut (100) and the M6 Washer (86) onto
the Low Cable (72) two complete turns.
1. Additional slack can be removed from the cables by tightening
a cable into the M6 Locknut (100) inside of a Clip (53).
2. To do this, slide the Cable Stop (52) away from the Clip and use
a pair of pliers or a screwdriver to tighten the Locknut.
3. Then, replace the Cable Stop.
Do not overtighten the cables. If a cable tends to slip off
the pulleys often, the cable may have become twisted.
Remove the cable and reinstall it.
If a cable needs to be replaced, contact the Trojan Call Centre
on 0861 876 526.
40
74
104
63
58
40
79
72
86
100
40
79
63
104
40
47
58
52
53
Cable
100
Cable
52
53
79
79
40
58
58
63
63
86
104
104
100
40
40
40
47
74
72
#21M05T035 Multifunction Smith Machine UM A4.indd 58 2021/06/24 11:28 AM