Trojan POWER GYM 1.0 - Cable 36 Installation; Step 10: Cable 36 Pulley System

17
POWER GYM 1.0
STEP 10: CABLE 36
Installing the pulley system:
1. Attach 1 open side of Cable 36 to the Leg Extension Frame (6) using 1 Hex Bolt (63), 2 Washers (68) and
1 Nylon nut (71) and thread cable under Pulley (J).
2. Install Pulley (32)
J
and 2 Pulley Hooks (55) to the Front Base Frame (2) using 1 Hex Bolt (59), 2 Washers (67)
and 2 Nylon Nuts (70).
3. Install Pulley (32)
H
and 2 Pulley Hooks (55) to the Reverse U (20) using 1 Hex Bolt (59), 2 Washers (67) and
2 Nylon Nuts (70).
4. Install Pulley (32)
K
and 2 Pulley Hooks (55) to the Front Base Frame (2) using 1 Hex Bolt (59), 2 Washers (67)
and 2 Nylon Nuts (70).
5. Install Pulley (32)
L
and 2 Pulley Hooks (55) to the Front Base Frame (2) using 1 Hex Bolt (59), 2 Washers (67)
and 2 Nylon Nuts (70).
6. Attach 1 x Chain (42) to the nal open end of Cable 36.
7. Attach Chain (42) to Front Base Frame (2) using 1 x Pothook (29).
Threading the cable through the pulley system:
1. Thread Cable 36 under Pulley (32)
J
and up towards Pulley (32)
H
.
2. Thread Cable 36 over Pulley (32)
H
and back down towards Pulley (32)
K
.
3. Thread Cable 36 under Pulley (32)
K
and back up towards Pulley (32)
L
.
4. Thread Cable 36 over Pulley (32)
L
and back down.
ASSEMBLY STEPS
STEP 10
37
Step 1 Step 2 Step 3
36
37
35
36
37
36
36
35
35
26
B
D
A
C
E
F
G
L
H
K
J
#19M02T008 Power Gym 1.0 UM VERSION 4.indd 17 29/05/2019 13:30